Having another play with the Inspiring Imperfections dies (part of the Kintsugi Inspirations Suite Collection) I slightly altered the Vase die image by cutting the top portion off - with the bottom of the same die!
After cutting the case out normally I then placed the base of the die at the top of the vase, laying over to cut the top portion off and ran it through the Stampin' Cut & Emboss machine again.
The ribbon rosette has been created by cutting a section of the Gold Striped 3/8" (1 cm) Mesh Ribbon and pulling on gold tread that runs through the middle of the ribbon. I did this from both ends (so that I didn't just pull the tread out) and pushed it together to gather. I tied the gold thread together and fixed it in place on the card with Tear & Tape.
For the inside of the card, I used the "cracked" stamps in one corner, from the Inspiring Imperfections Stamp Set. As they are photopolymer stamps, they can be manipulated (bent) to change the shape to fit the area.
If you have any other questions about this card, feel free to contact me!
On to the next one!
No comments:
Post a Comment